Filter
Top Products
Sample IMUX Configuration
HSIM-W85 User’s Guide 4-15
4.3 SAMPLE IMUX CONFIGURATION
The following is a sample of a common configuration.
To perform an IMUX configuration for the setup shown in Figure B-1, in
Appendix B, follow these steps:
1. To add channels to an IMUX group:
Enter: imux 1 -ac 1 29
(This adds interface 29 to the group id 1 in the imux id 1.)
To display the setup so far:
Enter: imux 1
Figure 4-3 shows the imux setup for group id 1 so far:
Figure 4-3 Adding Channels to an IMUX Group
2. After all the desired channels have been added to the group (four were
put in the group in this example), the group must be enabled:
Enter: imux 1 -eg 1
The screen shows the response to the imux command to enable
group 1 in Figure 4-4.
imuxsetup1
-> imux 1 -ac 1 29
# Inverse Multiplexer channel with ifIndex 29 added to group 1
-> imux 1
#
# WAN Inverse Multiplexer 1 Status: Disabled
#
# Inverse WAN Available Xmit Byte Inverse
# Multiplexer Group Physical BW Count Multiplexer Channel
# ID Admin Status Number (bits/sec) (bytes) ID IfIndex Status
#-------------------------------------------------------------------------------------------------------------
# 1 Disabled 22 1536000 0 1 29 INACTIVE
#
#
# Number of WAN Inverse Multiplexer Groups currently programmed : 1
#
# Number of WAN Inverse Multiplexer Channels currently programmed : 1