Filter
Top Products
DIP Switch Settings
Changing a DIP Switch Setting
This printer has two control modes: BJ-10e mode, which emulates the
IBM Proprinter X24E or the Canon BJ-130e, and Epson LQ mode,
which emulates the Epson LQ-510. The default setting is BJ-10e mode.
If you change this to Epson LQ mode, the default settings also change.
Function Setting
Code page 437 (USA)
Character set Character Set 1
Horizontal tab stops Every 8 columns
Buffer Input = 37 KB
Download = 0 KB
Printer control mode BJ-10e
Emulation IBM X24E
The DIP switch settings control various printer functions, such as the
page length and character set you want to use. The DIP switches are
located on the inside of the printer under the paper cover.
A DIP switch is OFF when it is down, and ON when it is up. The
factory default setting for each DIP switch is OFF.
The printer function defined by the DIP switches are determined by the
printer control mode. DIP switch 11 selects the printer control mode.
When DIP switch 11 is OFF, the printer is in BJ-10e mode; when DIP
switch 11 is ON, the printer is in Epson LQ mode.
To change the DIP switch setting, follow these steps:
1. Make sure the printer is turned off.