Filter
Top Products
5
After selecting or entering a value, press
[Start/Copy].
6
Repeat steps 4 and 5 as needed.
7
When the operation is complete, press [Stop].
Registration ends and the fax returns to standby
mode.
Note
After 60 seconds of no operation panel input, the fax returns to standby mode and any unregistered
changes are lost.
Entering a number
Whenever you are prompted to enter a fax number or a telephone number, follow these procedures.
Use the numeric buttons to enter the number.
¶ You can enter up to 20 digits for your fax number or 50 digits for a speed dialling number.
¶ Be sure to enter the appropriate area code if dialling outside the area served by your local exchange.
¶ You cannot enter dashes, slashes, commas, or other punctuation.
Use the One-touch Speed Dialling buttons as follows:
¶ To enter a space between numbers, press [Space].
¶ If you make a mistake, press [Clear] and enter the number again.
¶ To erase a previously registered number, press [Clear]. You can also enter a new
number over the old one.
If you need to enter a pause for any reason,
¶ Press [Redial/Pause] at the desired point in the sequence when entering a series of
digits.
¶ A pause within a number is 2 seconds long*. The length of this pause can be
adjusted. See MID PAUSE SET in TX SETTINGS, p. 87. A pause at the end of
a number is fixed at 10 seconds.
* 4 seconds long in the UK and Hong Kong.
Start/Copy
DATA ENTRY OK
Stop
TEL=
Send Options Report
Cleaning
R Space
Clear Tone
D.T.
REGISTERING YOUR NAME AND NUMBER
22222222222222222222222222222222222222222222
29