Filter
Top Products
3
If no errors are found, the indicator, indicator and the selected
paper feed indicator light up, and the message
or
<00 LIPS> appears on the display when the printer is ready to print.
The information shown on the LCD display is as follows:
Turning Off the Printer
The printer should be turned off as described in the following procedure. The
procedure for turning off the power differs depending on whether or not the hard
disk has been installed. (LBP-2810 only)
IMPORTANT
•
If the hard disk has been installed in the printer, you should follow the designated
procedure when turning off the power to protect the hard disk. (LBP-2810 only) (
→
P. 4)
•
If the printer is connected to a network, make sure that the printer is not printing data
from another personal computer before turning off the power.
•
If the power is turned off while the
indicator is on, the print data remaining in the
memory of the printer and the print data being spooled in the hard disk are erased
(except for the data stored in the box). Press
and then select
to
output any important print data, or wait until printing is complete, before turning off the
power. (
→
P. 65)
•
Do not turn off the power to the printer in the following situations:
- While printing.
- During the self-diagnostic test performed immediately after the power has been turned on.
- When the message that NVRAM is initializing or writing data is displayed.
- When the message that Flash Memory is initializing or deleting data is displayed. (LBP-
2810 only)
-When the message
or
is displayed.
•
If the printer has the hard disk installed, make sure that the HDD indicator is not on. If the
power is turned off while the HDD indicator is on (the hard disk is reading or writing data),
the hard disk may be damaged and become unusable. (LBP-2810 only)
Ready to print and no
data is being processed
for printing.
Currently selected
paper feed size.