Filter
Top Products
8
3) Attaching Cartridge Chips – un chipped CISS unit only
If you have purchased a pre chipped system please proceed to section 4) on page 10
Your original cartridge chips must be transferred onto the CISS cartridges. Please
follow the following steps carefully
a) Turn on your printer and open the cover. The cartridge holder will move to the
cartridge change position. Remove power cable from the back of your printer.
Remove the cartridges from the printer.
b) Using a Stanley knife or sharp blade remove the two plastic lugs which hold the
chip in place. The chips are colour specific so ensure you do not mix them
up as they will not work if they are attached incorrectly
c) Gently lift the chip from the cartridge. Never pry off the chip particularly from
the top of the chip as you may damage the sensitive electronics on the rear of
the chip.
X