Filter
Top Products
Chapter 3 Avaya P460 Chassis and Module Installation
Avaya P460 Installation and Maintenance Guide 15
Figure 3.9 Installing the P460 Supervisor Module
Key
a Open locking handle
b Closed locking handle
To install a Supervisor module:
1 Remove the blanking plate or installed module as appropriate.
2 Open the locking handles at the edge of the front panel.
3 Position the module in the slot as shown in Figure 3.9.
4 Gently slide the module in.
L Ensure the hooks on the locking handle are aligned with the matching holes on
the chassis.
5 Close the locking handles.
X The module slides back and connects to the backplane.
6 Gently tighten the screws.
L For information on configuring redundant supervisor modules, refer to
“M460ML-SPV Supervisor Module Redundancy“ on page 35.
3
3
P460
a
b