Filter
Top Products
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
Section 1: Safety
1-1
1. SAFETY
Read through this document in its entirety and understand all warnings and
precautions before attempting to operate the projector.
Do not look into the projector lens when the lamp is on. The bright light
y
may result in permanent eye damage.
To reduce the risk of re or electric shock, do not expose this projector to
y
rain or moisture.
Do not open or disassemble the projector as this may cause electric shock.
y
When replacing the lamp, allow the projector to cool, and follow all
y
replacement instructions.
When you turn the projector off, wait 90 seconds for the projector to cool
y
down before you disconnect the projector from power.
Cooling the lamp during the ignition phase may lead to ignition failures.
y
After a successful lamp ignition, keep the lamp burning for at least 15
minutes to maintain lamp life.
When the lamp is approaching the end of its life, the message “Lamp is
y
approaching the end of its useful life in full power operation” appears on
the screen. Change the lamp when the warning message appears.
All installation and maintenance procedures must be performed by a
y
Christie accredited service technician.
Keep all combustible material away from the concentrated light beam of
y
the projector.
Position all cables where they cannot contact hot surfaces or be pulled or
y
tripped over.
WARNING