Filter
Top Products
Programming Reference
VERSAJET
[Notes]
In a count-up setting, when the GS c is executed, the counter value exceeds the
maximum value( bL+bH x 256), restart counting from the minimum value ( aL + aH x
256).
In a count-down setting, when GS c is executed, the counter value is below minimum
value( bL+bH x 256), restart counting from the maximum value ( aL + aH x 256).
In a count-stop setting, when executing GS c, the counter value is not changed.
This command does not change the counter value. The counter value is set by GS C 2.
Settings of this command are effective until ESC @ is executed, the printer is reset, or
the power is turned off.
The value of the counter is updated when executing GS c.
146