Filter
Top Products
GS P
Programming Reference
VERSAJET
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P x y
Commands using y: ESC 3, ESC J
Hex 1D 50 x y
Decimal 29 80 x y
[Range] 0 ≤ x ≤ 255, 0 ≤ y ≤ 255
[Default] x = 203, y = 203
[Description] Sets the horizontal and vertical motion units to 1/x and 1/y inch, respectively.
When x = 0, the default setting of the horizontal value is used.
When y = 0, the default setting of the vertical value is used.
[Notes]
The horizontal direction is perpendicular to the paper feed direction and the vertical
direction is the paper feed direction.
The horizontal and vertical motion units indicate the minimum pitch used for calculating
the values of related commands.
In standard mode, the following commands use x or y.
Commands using x: ESC SP, ESC $, ESC \, GS L, and GS W.
In page mode, the following commands use x or y, when the starting position is set to
the upper left or lower right of the printing area using ESC T.
Commands using
x: ESC 3, ESC J, ESC W, GS $, and GS \
Commands using y: ESC SP, ESC $, ESC W, ESC \
152