Filter
Top Products
5-4
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-06
Chapter 5 Troubleshooting Lightweight Access Points
Power Injector
Power Injector
When the power injector is powered up, it applies 48-VDC to the dual-coax cables to the access point.
When power is applied to the access point, the unit activates the bootloader and begins the POST
operations. The access point begins to load the Cisco IOS image when the POST operations are
successfully completed. Upon successfully loading the image, the unit initializes and tests the radio.
The power injector LED is shown in Figure 5-2.
Figure 5-2 Power Injector
Controller
status
Alternating green, red, and amber
1
Connecting to the controller.
Note If the access point remains in this mode for more than five
minutes, the access point is unable to find the controller.
Ensure a DHCP server is available or that controller
information is configured on the access point.
Message
type
Ethernet
LED
Status
LED
Radio
LED Meaning
1. This status indication has the highest priority and overrides other status indications.
Table 5-1 LED Signals (continued)
Message
type
Ethernet
LED
Status
LED
Radio
LED Meaning
1 Dual-coax Ethernet ports (F-Type connectors) 4 Ethernet LAN port (RJ-45 connector)
2 Power LED 5 Console serial port (RJ-45 connector)
3 Power jack
117189
CISCO AIRONET
POWER INJECTOR
54
11
3
2