Cisco Systems 159330 Power Supply User Manual


 
3-8
Cisco AC/DC Power System User Guide, R1.0
May 2006
Chapter 3 Component Replacement
3.2.4 Replace a Rectifier
Figure 3-8 Removing a Circuit Breaker
Step 5
Remove the alarm cable connections from the rear of the breaker (Figure 3-8).
Step 6 Pull the breaker straight out from the 1RU Distribution Shelf.
Step 7 To reinstall a replacement 1RU Distribution Shelf see the “2.2.2 Install the 1 RU Distribution Shelf”
procedure on page 2-6.
3.2.4 Replace a Rectifier
Note For more information on uninstalling a rectifier, see the “4.2.2.3 Remove Modules” section on
page 4-3.
Step 1 Locate the rectifier that is to be removed.
Step 2 Loosen the mounting screws to allow the rectifier handle to open (Figure 3-9 #1).
Step 3 Grasp the top of the handle and pull down until the handle locks into the open position (Figure 3-9 #2).
124757