Filter
Top Products
Chapter 2 Installation
Verifying the Installation
2-12
Cisco 1760 Modular Access Router Hardware Installation Guide
78-13342-03
Figure 2-8 Connecting Power
Step 2
Connect the other end of the separate power cord to a power outlet.
Step 3 Turn the power switch on ( | ).
Step 4 Confirm that the router has power by checking that the PWR LED is on.
Verifying the Installation
You can verify that you have correctly installed the router by checking the
following LEDs:
• PWR—On when power is being supplied to the router.
• OK—On when the router software is loaded and functional. Blinking means
that the router is performing a power-on self-test (POST).
• ETH ACT—Blinking when there is network traffic on the local Ethernet
LAN.
100-240V~
1.5 MAX/1.5A MAX
50-60 Hz
60948