Filter
Top Products
Index
IN-5
Cisco Secure Router 520 Series Software Configuration Guide
OL-14210-01
loopback interface, configuring 1-6 to 1-8
low latency queuing
See LFQ
M
meminfo command C-9
metrics
RIP
B-2
mode configuration, applying to crypto map 6-5
modes
See command modes
N
NAT
configuration example
3-8, 4-9
configuring with PPPoA 4-7
configuring with PPPoE 3-1, 3-5
overview B-5 to B-6
See also Easy IP (Phase 1)
NCP
B-3
network address translation
See NAT
network configuration, preparing for
1-2
Network Control Protocols
See NCP
network protocols
B-2
network scenarios
See configuration examples
nonvolatile RAM
See NVRAM
NVRAM, saving changes to
A-6
O
overloading, defined B-6
P
packets, ATM, displaying 12-7
PAP B-3
parameters, setting up global 1-4
Password Authentication Protocol
See PAP
password protection
A-4
passwords
recovery
12-9 to 12-12
resetting 12-11
setting A-4
permanent virtual circuit
See PVC
permit command
B-9
ping atm interface command 12-2
Point-to-Point Protocol
See PPP
policy-based routing
B-7
policy lookup, enabling 6-6, 7-4, 7-5
port assignments, common D-1 to D-2
port labels for interfaces 1-3
port numbers currently assigned D-1 to D-2
PPP
authentication protocols
B-3
fragmentation B-7
interleaving B-7
overview B-3
PPP/Internet Protocol Control Protocol
See IPCP
PPPoA, configuration example
4-9
PPPoE
client
3-1
configuration example 3-8
configuring 3-1
verifying your configuration 3-8
prerequisites, for configuration 1-2
privileged EXEC commands, accessing A-5
privileged EXEC mode A-2, A-3