Filter
Top Products
20
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
78-11631-02 Rev. A0
Configuring the Content Switching Module
If the Multilayer Switch Function Card (MSFC) is used on the next hop router on either the client
or the server side VLAN, then the corresponding Layer 3 VLAN interface must be configured.
Caution The MSFC cannot be used simultaneously as the router for both the client and the server side. Do not
configure the Layer 3 VLAN interface for both the client and the server side.
This example shows how to configure the Layer 3 VLAN interface:
Router>
Router> enable
Router# config
Router(config)# interface vlan 130
Router(config-if)# ip address 10.10.1.10 255.255.255.0
Router(config-if)# no shutdown
Router(vlan)# exit
Figure 7 shows an overview of the configuration process. Required and optional operations are shown.
Note Configuring policies is not necessary for basic Layer 4 load balancing.
Figure 7 Configuration Overview
Configure VLANs (required)
Configure virtual servers (required)
Configure server farm (required)
Configure policies (optional)
Configure real servers (required)
Configure other optional
parameters
Save and restore
configurations
47529