Filter
Top Products
5-7
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Chapter 5 Replacing Cisco ASR 9001 Router Components
Removing and Replacing AC or DC Power System Components
Figure 5-3 Removing or Installing an AC or DC Power Module (AC power shown)
Installing an AC or DC Power Module
To install an AC or DC power module (Figure 5-3):
Step 1 Slide the power module into the open bay until it mates with its backplane connector. Make sure that
keying lever locks with the chassis.
Step 2 Attach the power cabling to the power module.
Step 3 Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator
does not light up, see Troubleshooting the Power Subsystem, page 4-3.
332383