Filter
Top Products
2-8
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Chapter 2 Unpacking and Installing the Chassis
Installing the Cisco ASR 9001 Chassis
Installing the Chassis in a Four-Post Rack
If you are installing the chassis without air plenum kit, you will need two side mounting brackets used
to attach the chassis to the rear posts as shown in Figure 2-5. See Before you Begin, page 2-4 for
mounting bracket information.
To install the chassis in a four-post open rack, follow these steps:
Step 1 Follow the steps in Installing the Chassis in a Two-Post Rack, page 2-6 to secure the chassis to the front
rack posts.
Step 2 For rear mounting, align each rear mounting bracket (Figure 2-5) with the screw holes on the chassis and
the mounting holes in the rear rack posts.
Step 3 Fully tighten both screws to the chassis on each side to secure the chassis to the rear posts.
Figure 2-5 Installing the Cisco ASR 9001 Router Chassis in a Four-Post Rack
1 Three screws on each side (minimum two)
to attach the chassis to the rack.
2 Two rear mounting brackets on each side to attach
the chassis to the rear rack posts.
1
2
1
2
364434