Filter
Top Products
3-15
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Chapter 3 Installing Modules and Cables in the Chassis
Cable Management
Installing a Cable Management Tray
To install a cable-management tray, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Position the cable-management tray at the bottom of the chassis front panel.
Figure 3-9 Cable-Management Tray Installation and Removal
Step 3
Insert and tighten the captive screw(s) to secure the tray. (Figure 3-9).
Step 4 Connect all the cables to the intended ports and pass them through the cable management tray in an
organized manner.
Removing a Cable-Management Tray
To remove a cable-management tray, follow these steps (Figure 3-9):
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Note the current interface cable connections to the ports on the RP.
Step 3 Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP
interface.
1 Cable-Management Tray
1
332147