Filter
Top Products
4-7
2. Setup Menu Procedures
Setup Menu Settings Chapter 4
(8) Press the
Set
key. The first setting item of the selected submenu (Level 3) is displayed. The menu on
Level 4 may be displayed depending on the main menu that is selected (☞ p. 4-11).
Select the menu in the same manner.
This example describes the condition when the
[Ethernet Setup]
is selected in the level 3.
Useful Tip
The
[Network Setup]
settings are required when the printer is connected to a network. In this case, the
[Protocol Setup]
-
[TCP/IP Setup]
is set directly for this explanation. However, do not actually set only
[Protocol Setup]
but set also
[Service Setup]
and
[Port Setup]
simultaneously.
(9) Use the ▼ and ▲ keys to select the setting value of the item. (In this example, the setting value is
Yes /N o.)
(10) Press the
Set
key. The following setting item is displayed.
(11) Use the ▼ and ▲ keys to switch the numeric characters when performing the settings. Press the
key to shift the cursor (underlined section) to switch the following numeric characters.
(12) Set all the numeric characters and press the
Set
key. The following setting item is displayed.
(13) Set this item by the same procedure as described in step (11) and press the
Set
key. This ends the
Ethernet setting and operation shifts to the TCP/IP setup end menu.
(14) Continue these procedures to set the other items in the TCP/IP Setup menu.
(15) In the Setup menu, set “Save Changes” to “Yes.” (☞ p. 4-10).
TCP/IP Setup
Ethernet Setup
Set
key
Enable TCP/IP
No
Enable TCP/IP
No
Enable TCP/IP
Yes
▼
▲
Enable TCP/IP
Yes
Set
key
IP Address
127.0.0.1
▼
IP Address
127
.0.0.1
IP Address
128
.0.0.1
▼
▲
IP Address
128.0
.0.1
key
▼
IP Address
247.123.0.1
Set
key
Subnet Mask
225
.225.225.0
Subnet Mask
247
.255.123.1
Set
key
TCP/IP Setup
Exit