Filter
Top Products
Chapter 6 Maintaining the Router
Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
6-62
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Figure 6-34 Removing and Installing a Switch Fabric Card
Removing a Switch Fabric Card
To remove a switch fabric card, see Figure 6-34 and follow these steps:
Step 1 Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Step 2 Loosen the captive screw on each side of the SFC faceplate.
Step 3 Grasp the card ejector levers and pivot them away from the SFC faceplate.
Step 4 Slide the SFC halfway out of the slot, then stop.
Step 5 Touching only the metal card carrier, use your free hand to support the bottom of
the SFC.
1 SFC 3 Ejector lever (2)
2 Captive screw (2) – –
101410
SLOT-0
G
IG
A
BIT
R
OU
TE PR
O
C
ESS
O
R
SLOT-1
COLL
LINK
TX
RX
RJ-45
MII
RESET
AUX
EJECT
CONSOLE
CISCO 12000
SE
RIES
G
IG
A
B
IT
S
W
I
T
C
H
R
O
U
T
E
R
1
2
3