Filter
Top Products
7-6
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-7113-05
Chapter 7 Troubleshooting the Installation
Packing a SPA for Shipment
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Note These instructions assume that the SPA and cable-management brackets have been removed from the
router according to the recommended procedures specified in this guide.
To pack a SPA and the cable-management brackets for shipment, perform the following steps:
Step 1 Open the Thermoform container and place the SPA and each of the cable-management brackets into the
appropriate cavities.
Caution Always handle the SPA by the carrier edges and handle; never touch the SPA components or connector
pins.
Step 2 Close the Thermoform container. Be sure to lock the snaps securely.
Step 3 Check that the Thermoform container is fully closed. Apply tape or a label closure over the opening to
ensure the container stays closed during shipping.
Step 4 Place the Thermoform container into the carton.
Step 5 Close the carton.
Step 6 Apply tape over the carton flap to ensure the carton stays closed during shipping.