Filter
Top Products
3-49
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x
Chapter 3 Configuring Fibre Channel Interfaces
Configuration Examples for Fibre Channel Interfaces
Step 7 Select the interfaces fc 4/7 through fc 4/10.
switch# config t
switch(config)# interface fc 4/7 - 10
Step 8 Configure the port speed, rate mode, and port mode on the interfaces.
switch(config-if)# switchport speed 1000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Step 9 Enable the interfaces and return to configuration mode.
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Configuration Example for 24-Port 4-Gbps Module Interfaces
These steps describe how to configure the example shown in Figure 4-8 on page 4-13:
Step 1 Select interfaces fc 3/1 through fc 3/3.
switch# config t
switch(config)# interface fc 3/1 - 3
Step 2 Configure the port speed, rate mode, and port mode on the interfaces.
switch(config-if)# switchport speed 4000
switch(config-if)# switchport rate-mode dedicated
switch(config-if)# switchport mode e
Step 3 Enable the interfaces and return to configuration mode.
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Step 4 Select the interfaces fc 3/4 through fc 3/6.
switch# config t
switch(config)# interface fc 3/4 - 6
Step 5 Configure the port speed, rate mode, and port mode on the interfaces.
switch(config-if)# switchport speed 1000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Step 6 Enable the interfaces and return to configuration mode.
switch(config-if)# no shutdown
switch(config-if)# exit
switch#