Filter
Top Products
2-33
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x
Chapter 2 Configuring Interfaces
Configuring Interfaces
Step 10
switch(config-port-monitor)# counter
link-loss poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta link failure counter, poll
interval in seconds, the thresholds in percentage,
and the event IDs of events to be triggered.
Step 11
switch(config-port-monitor)# counter
protocol-error poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta protocol error poll interval in
seconds, the thresholds in percentage, and the
event IDs of events to be triggered.
Step 12
switch(config-port-monitor)# counter
rx-performance poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta Rx counter poll interval in
seconds and thresholds in percentage.
Step 13
switch(config-port-monitor)# counter
signal-loss poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta signal loss poll interval in
seconds, the thresholds in percentage, and the
event IDs of events to be triggered.
Step 14
switch(config-port-monitor)# counter
state-change poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta state change poll interval in
seconds, the thresholds in percentage, and the
event IDs of events to be triggered.
Step 15
switch(config-port-monitor)# counter
sync-loss poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta sync loss poll interval in
seconds, the thresholds in percentage, and the
event IDs of events to be triggered.
Step 16
switch(config-port-monitor)# counter
tx-performance poll-interval
seconds
delta
rising-threshold
percentage1
event
event-id
falling-threshold
2
percentage2
event
event-id
Specifies the delta Tx counter poll interval in
seconds and thresholds in percentage.
Step 17
switch(config-port-monitor)# no counter
sync-loss
Reverts to the default policy for sync loss
performance counter values.
Step 18
switch(config-port-monitor)# no counter
tx-performance
Reverts to the default policy for Tx performance
counter values.
Step 19
switch(config-port-monitor)# monitor counter
rx-datarate
Turns on Rx performance counter.
switch(config-port-monitor)# monitor counter
tx-datarate
Turns on Tx performance counter.
switch(config-port-monitor)# no monitor
counter tx-datarate
Turns off Tx performance counter.
switch(config-port-monitor)# no monitor
counter sync-loss
Turns off monitoring sync loss.
switch(config-port-monitor)# no monitor
counter state-change
Turns off monitoring state change.
1. The error-pkt-port counter, the err-pkt-from xbar counter, and the err-pkt-to-xbar counter are all ASIC counters. All ASIC counters are
turned off by default. The Asic counters are queried every 10 seconds. If the ASIC corresponding to a specific ASIC counter sends or
receives any error packets during a 10-second interval, an error frame event occurs during the interval for that counter.
2. Falling-threshold value should be less than the rising-threshold value.
Command Purpose