Filter
Top Products
36-8
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 36 Configuring SNMP
How to Configure SNMP
Note Though visible in the command-line help strings, the fru-ctrl, insertion, and removal keywords are not
supported.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
Table 36-4.
Default SNMP Settings
How to Configure SNMP
Disabling the SNMP Agent
The no snmp-server global configuration command disables all running versions (Version 1,
Version 2C, and Version 3) on the device. No specific Cisco IOS command exists to enable SNMP. The
first snmp-server global configuration command that you enter enables all versions of SNMP.
vlandelete Generates SNMP VLAN deleted traps.
vtp Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 36-4 Switch Notification Types (continued)
Notification Type
Keyword Description
Table 36-5 Default SNMP Settings
Feature Default Setting
SNMP agent Disabled
1
.
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration
commands.
SNMP trap receiver None configured.
SNMP traps None enabled except the trap for TCP connections (tty).
SNMP version If no version keyword is present, the default is Version 1.
SNMPv3 authentication If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
SNMP notification type If no type is specified, all notifications are sent.
Command Purpose
Step 1
configure terminal Enters global configuration mode.
Step 2
no snmp-server Disables the SNMP agent operation.
Step 3
end Returns to privileged EXEC mode.