Filter
Top Products
Chapter 5 Configuring Firewall Load Balancing
Displaying Firewall IP Routes
5-16
Cisco Content Services Switch Security Configuration Guide
OL-5650-02
Table 5-1 describes the fields in the show flows output.
Displaying Firewall IP Routes
Use the show ip routes firewall command to display all static firewall routes. For
example:
(config)# show ip routes firewall
Table 5-2 describes the fields in the show ip routes firewall output.
Table 5-1 Field Descriptions for the show flow Command
Field Description
Src Address The source address for the flow
SPort The source port for the flow
Dst Address The destination address for the flow
DPort The destination port for the flow
NAT Dst Address The NAT destination address
Prot The protocol of the flow (TCP or UDP)
InPort The interface port for the in flow
OutPort The interface port for the out flow
Table 5-2 Field Descriptions for the show ip routes firewall Command
Field Description
Prefix/length The IP address and prefix length for the route.
Next hop The IP address for the next hop.
If The ifIndex value that identifies the local interface through
which the next hop of this route should be reached.
Type The type of the route entry. The type is remote.
Proto The protocol for the route, firewall.
Age The maximum age for the route.
Metric The metric cost for the route.