Filter
Top Products
10-5
Cisco ONS 15310-CL, ONS 15310-MA, and ONS 15310-MA SDH Ethernet Card Software Feature and Configuration Guide, R9.1 and R9.2
78-19415-01
Chapter 10 Configuring Link Aggregation on the ML-Series Card
Configuring Link Aggregation
Caution
The POS channel interface is the routed interface. Do not enable Layer 3 addresses on any physical
interfaces. Do not assign bridge groups on any physical interfaces because doing so creates loops.
To assign POS interfaces to the POS channel, perform the following procedure, beginning in global
configuration mode:
POS Channel Configuration Example
Figure 10-2 shows an example of POS channel configuration. The associated code for ML_Series A is
provided in Example 10-3 and for ML_Series B in Example 10-4.
Figure 10-2 POS Channel Example
Example 10-3 ML_Series A Configuration
no ip routing
bridge 1 protocol ieee
!
!
interface Port-channel1
no ip address
bridge-group 1
!
interface FastEthernet0
no ip address
bridge-group 1
Command Purpose
Step 1
Router(config)# interface pos
number
Enters the interface configuration mode to
configure the POS interface that you want to
assign to the POS channel.
Step 2
Router(config-if)# channel-group
channel-number
Assigns the POS interface to the POS channel. The
channel number must be the same channel number
that you assigned to the POS channel interface.
Step 3
Router(config-if)# end
Exits to privileged EXEC mode.
Step 4
Router# copy running-config startup-config
(Optional) Saves the configuration changes to
NVRAM.
pos 0pos 0
bridge-group 1
bridge-group 1
port-channel 1
bridge-group 1
bridge-group 1
bridge-group 1
port-channel 1
bridge-group 1
pos 1pos 1
124410
SONET STS-N
ML_Series A
ML_Series B