Filter
Top Products
17-4
Cisco ONS 15310-CL, ONS 15310-MA, and ONS 15310-MA SDH Ethernet Card Software Feature and Configuration Guide, R9.1 and R9.2
78-19415-01
Chapter 17 CE-Series Ethernet Cards
CE-100T-8 Ethernet Card
Figure 17-3 End-to-End Ethernet Link Integrity Support
Note
Some network devices can be configured to ignore a loss of carrier condition. If a device configured to
ignore a loss of carrier condition attaches to a CE-100T-8 card at one end, alternative techniques (such
as use of Layer 2 or Layer 3 keep-alive messages) are required to route traffic around failures. The
response time of such alternate techniques is typically much longer than techniques that use link state as
indications of an error condition.
Enhanced State Model for Ethernet and SONET Ports
The CE-100T-8 supports the Enhanced State Model (ESM) for the Ethernet ports, as well as for the
SONET circuit. For more information about the ESM, refer to the “Administrative and Service States”
appendix in the Cisco ONS 15454 Reference Manual.
The Ethernet ports can be set to the ESM service states including the In-Service, Automatic In-Service
(IS,AINS) administrative state. IS,AINS initially puts the port in the Out-of-Service and Autonomous,
Automatic In-Service (OOS-AU,AINS) state. In this service state, alarm reporting is suppressed, but
traffic is carried. After the soak period passes, the port changes to In-Service and Normal (IS-NR).
Raised fault conditions, whether their alarms are reported or not, can be retrieved on the CTC Conditions
tab or by using the TL1 RTRV-COND command.
Two Ethernet port alarms/conditions, CARLOSS and TPTFAIL, can prevent the port from going into
service. This occurs even though alarms are suppressed when a CE-100T-8 circuit is provisioned with
the Ethernet ports set to the IS,AINS state, because the CE-100T-8 link integrity function is active and
ensures that the links at both ends are not enabled until all SONET and Ethernet errors along the path
are cleared. As long as the link integrity function keeps the end-to-end path down, both ports will have
at least one of the two conditions needed to suppress the AINS-to-IS transition. Therefore, the ports will
remain in the AINS state with alarms suppressed.
ESM also applies to the SONET circuits of the CE-100T-8 card. If the SONET circuit is set up in
IS,AINS state and the Ethernet error occurs before the circuit transitions to IS, then link integrity will
also prevent the circuit transition to the IS state until the Ethernet port errors are cleared at both ends.
The service state will be OOS-AU,AINS as long as the administrative state is IS,AINS. When there are
no Ethernet or SONET errors, link integrity enables the Ethernet port at each end. Simultaneously, the
AINS countdown begins as normal. If no additional conditions occur during the time period, each port
transitions to the IS-NR state. During the AINS countdown, the soak time remaining is available in CTC
and TL1. The AINS soaking logic restarts from the beginning if a condition appears again during the
soak period.
A SONET circuit provisioned in the IS,AINS state remains in the initial Out-of-Service (OOS) state until
the Ethernet ports on each end of the circuit transition to the IS-NR state. The SONET circuit transports
Ethernet traffic and counts statistics when link integrity turns on the Ethernet port, regardless of whether
this AINS-to-IS transition is complete.
Ethernet port
115796
Tx
Rx
Ethernet port
Tx
Rx
STS-N
SONET
ONS 310 ONS 310