Filter
Top Products
26
PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
OL-3743-02
Configuring the HP ESCON PA
Configuring the HP ESCON PA
To continue your port adapter installation, you must configure the HP ESCON PA interface. The
instructions that follow apply to all supported platforms. Minor differences among the platforms—with
Cisco IOS software commands—are noted.
This section contains the following subsections:
• Using the EXEC Command Interpreter, page 26
• Configuring the HP ESCON PA Interface, page 27
• Checking the Configuration, page 28
• Upgrading Your HP ESCON PA Microcode, page 33
• Using Flash Memory, page 36
• Using SanDisk Devices, page 38
• Running HP ESCON PA Diagnostic Tests, page 39
Using the EXEC Command Interpreter
You modify the configuration of your router through the software command interpreter called the EXEC
(also called enable mode). You must enter the privileged level of the EXEC command interpreter with
the enable command before you can use the configure command to configure a new interface or to
change the existing configuration of an interface. The system prompts you for a password if one has been
set.The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket (>).
At the console terminal, use the following procedure to enter the privileged level:
Step 1 At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
privileged-level password as follows:
Router> enable
Password:
Step 2 Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
When you enter the correct password, the system displays the privileged-level system prompt (#):
Router#