Filter
Top Products
35
PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
OL-3743-02
Configuring the HP ESCON PA
18 .. unknown BC7BEC5D 51EB90 17 246184 Sep 18 2000 06:46:56 xcpa218-6_seg_802
19 .. unknown C09633A6 5A8284 18 562804 Sep 18 2000 06:47:09 xcpa218-6_seg_cmpc
20 .. unknown 0B58D705 5BFBEC 18 96488 Sep 18 2000 06:47:37 xcpa218-6_seg_csna
21 .. unknown 29DEAA84 630414 17 460712 Sep 18 2000 06:47:42 xcpa218-6_seg_eca
22 .. unknown 95CADB93 646BDC 21 91976 Sep 18 2000 06:48:05 xcpa218-6_seg_offload
23 .. unknown 82F8A3D6 657948 17 68844 Sep 18 2000 06:48:10 xcpa218-6_seg_pca
24 .. unknown 7EECB670 65B64C 18 15492 Sep 18 2000 06:48:13 xcpa218-6_seg_push
25 .. unknown B4A58886 72583C 18 827760 Sep 18 2000 06:48:14 xcpa218-6_seg_sslc
26 .. unknown 73CB2859 74CE68 19 161196 Sep 18 2000 06:48:56 xcpa218-6_seg_tcpip
27 .. unknown 0989F473 7F31C8 20 680672 Sep 18 2000 06:49:04 xcpa218-6_seg_tn3270
12373560 bytes available (8204744 bytes used)
To configure the microcode for an HP ESCON PA on a router configured with Cisco IOS
Release 12.1(5)T or later:
Step 1 Enter the privileged EXEC configuration mode using the enable command:
Router> enable
Password:
Router#
Note For complete information on the privileged EXEC configuration mode, refer to the “Using the EXEC
Command Interpreter” section on page 26.
Step 2 If you need to copy a new HP ESCON PA microcode image to your router’s Flash memory, refer to the
“Using Flash Memory” section on page 36, then proceed to Step 3.
Step 3 In privileged EXEC configuration mode, enter global configuration mode and specify that the console
terminal will be the source of the configuration subcommands:
Router# configure terminal
To load the microcode from an individual microcode image that is stored as a file on a Flash memory
card, enter the microcode command, the processor type, the specific memory location of the HP ESCON
PA microcode image, and the exact argument for filename (xcpa28-1 is used in this example):
Router(config)# microcode ecpa slot0:xcpa28-1
Router(config)# microcode reload
Note The microcode reload command is written automatically in the configuration file following the
microcode ecpa command when you modify the system default to load a microcode image.
The no microcode command cancels any existing instructions to load an image from a Flash memory
card and restores the default configuration:
Router(config)# no microcode ecpa slot0:xcpa28-1
Step 4 To save the configuration file, press Ctrl-Z (or type end), then copy the new configuration to NVRAM:
Router# copy running-config startup-config