Filter
Top Products
31
PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
OL-3743-02
Configuring the HP ESCON PA
Using the show diag Command
Display the type of port adapter installed in your system using the show diag command.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7200 Series and Cisco 7200 VXR Series Routers—Example Output of the show diag Command
Following is an example of the show diag command from a Cisco 7200 series router with an HP ESCON
PA installed in port adapter slot 4:
Router# show diag 2
Slot 2:
Escon Port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 00:05:00 ago
EEPROM contents at hardware discovery:
Hardware Revision :1.0
Top Assy. Part Number :800-06347-02
Part Number :73-4454-02
Board Revision :02
PCB Serial Number :18902852000
RMA History :00
Fab Version :02
Fab Part Number :28-3405-02
Product Number :PA-4C-EB
EEPROM format version 4
EEPROM contents (hex):
0x00:04 FF 40 02 10 41 01 00 C0 46 03 20 00 18 CB 02
0x10:82 49 11 66 02 42 30 32 C1 8B 31 38 39 30 32 38
0x20:35 32 30 30 30 04 00 02 02 85 1C 0D 4D 02 CB 94
0x30:50 41 2D 34 43 2D 45 42 00 00 00 00 FF FF FF FF
0x40:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x50:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Using the show interfaces Commands
Display information about a specific interface using the show interfaces command.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7200 Series and Cisco 7200 VXR Series Routers—Example Output of the show interfaces Command
Following is an example of the show interfaces channel command for an HP ESCON PA in port adapter
slot 4:
Router# show interface channel 4/0
Channel4/0 is up, line protocol is up
Hardware is Escon Channel
Internet address is 10.10.99.1/24
MTU 4472 bytes, BW 98304 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation CHANNEL, loopback not set
ECA adapter card