Filter
Top Products
Port Adapter Locations on the Supported Platforms
PA-FE-TX and PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
1-2
Figure 1-2 PA-FE-FX Port Adapter—Faceplate View
The PA-FE can be installed in the following slots on the hardware platforms described in this
document:
• VIP2—Port adapter slot 0 and port adapter slot 1
• Cisco 7200 series routers—Port adapter slot 1 and slot 2 of the Cisco 7202; port adapter slot 1
through slot 4 of the Cisco 7204 and Cisco 7204VXR; port adapter slot 1 through slot 6 of the
Cisco 7206 and Cisco 7206VXR
• Cisco uBR7200 series universal broadband routers—Port adapter slot 1 and slot 2 of the
Cisco uBR7246; port adapter slot 1 of the Cisco uBR7223
• Cisco 7100 series—Port adapter slot 3
Note Port adapters have a handle attached, but this handle is occasionally not shown to allow a full
view of detail on the port adapter’s faceplate.
Port Adapter Locations on the Supported Platforms
Figure 1-3 and Figure 1-4 show VIP2 models with installed port adapters. With the VIP2 oriented
as shown in Figure 1-3 or Figure 1-4, the left port adapter is in port adapter slot 0, and the right port
adapter is in port adapter slot 1.
In the Cisco 7000, Cisco 7507, and Cisco 7513 chassis, the VIP2 is installed vertically. In the
Cisco 7010 and Cisco 7505 chassis, the VIP2 is installed horizontally.
Figure 1-3 VIP2-15 or VIP2-40 with Two Port Adapters Installed—Horizontal Orientation
H6014
ENABLED
MII
LINK
FIBER
0
FAST ETHERNET
RX
TX
H6448
DRAM
SIMMs
Port adapter
in slot 0
Port adapter
in slot 1
SRAM
DIMM U5
CPU
Boot ROM
Bus connector
U6
U4
U2