Filter
Top Products
Firewall
Access Rules
Cisco RV320/RV325 Administration Guide 79
8
UDP timeout—Input the timeout value of UDP sessions. The default for UDP
timeout is 30 seconds.
Access Rules
Access rules limit access to the subnetwork by allowing or denying access by
specific services or devices identified by their IP address.
To open this page, select Firewall > Access Rules in the navigation tree.
To add or edit a service, click Service Management. This feature is described in
Adding or Editing a Service Name.
Adding an Access Rule to the IPv4 Access Rule Table
To add (or edit) an IPv4 access rule:
STEP 1 Click the IPv4 tab.
STEP 2 Click Add (or select the row and click Edit).
STEP 3 Select the Action, Allow or Deny, for this rule from the drop-down menu.
STEP 4 Select a Service from the drop-down menu.
STEP 5 Select Log packets matching this rule or No Log.
STEP 6 Select the Source Interface from the drop-down menu.
STEP 7 Select the Source IP address from the drop-down menu. If you selected Single,
enter the source IP address. If you selected Range, enter the range of source IP
addresses.
STEP 8 Select the Destination IP address from the drop-down menu. If you selected
Single, enter the destination IP address. If you selected Range, enter the range of
destination IP addresses.
STEP 9 Configure the Scheduling for this access rule by selecting the time. Select
Always for the access rule to be in effect 24 hours a day. Select Interval to set a
time, and enter the hours and minutes that the access rule is effective in the From
and To fields. For example, 07:00 to 20:00. The access rule does not allow
setting two time intervals.
STEP 10 Select the Effective On days of the week.