Filter
Top Products
Cisco IOS for S/390 Release 2.0 Release Notes 19
Cisco IOS for S/390 Unprefixed Messages and Codes
T01CF084W
Refresh of USSTAB failed, tbl_name not used in APP task task_num
Explanation
There was a negative response to REFRESH USSTAB(tbl_name) TASK(task_num)
operator command. tbl_name for APP task task_num was not specified in the active APPCFGxx
SERVICE segment.
Recommended Action Check the spelling of tbl_name and APP task task_num that may have
been entered correctly.
T01NT069I
HH:MM:SS - nnn active TCP connections
T01NT070I
LNI aaaaaaaa : bbb / ccc bytes/packdts in, at ddd bytes/sec
Syntax Description
T01NT071I
LNI aaaaaaaa: bbb/ccc/ bytes/packets out, at ddd bytes/sec
Syntax Description
Cisco IOS for S/390 Unprefixed Messages and Codes
The information in this section should be added to the Cisco IOS for S/390 Unprefixed Messages and
Codes manual.
C245xxxx (07xx) T012TCLS
The following table replaces Table 60 “X’C245’ Instance Codes” in the “API Diagnostic Codes”
chapter:
aaaaaaaa Hardware interface name
bbbb Total byte count.
ccc Total packet count.
ddd Rate based on the time difference from the last sampling.
aaaaaaaa Hardware interface name
bbbb Total byte count.
cccc Total packet count.
ddd Rate based on the time difference from the last sampling.
Table 6 X’C245’ Instance Codes
4-byte code 2-byte code Description
C2450001 0701 Unexpected abend