Filter
Top Products
48 Cisco IOS for S/390 Release 2.0 Release Notes
Converting from Cisco IOS for S/390 Release 1.0 to Cisco IOS for S/390 Release 2.0
Figure 13 IFSPARM and AUTH Statements
LOGGING Statement
One of the design goals of Cisco IOS for S/390 release 2.0 was to reduce the volume of message
output printed. SMF recording was enhanced to allow many of the events previously recorded only
by a message to be written to the SMF datasets.
Messages were renumbered so that each message now has a unique prefix, which includes both a
severity, and a component code to identify the area of the product which issued the message. The
LOGGING statement was added in IJTCFGxx to give you control over which messages will be
written to the log or to the console. Message routing can be controlled by severity and component,
using the LOGGING statement.
By default, many events previously reported by messages will go unreported in Cisco IOS for S/390
release 2.0. Some customers may prefer to continue seeing the same level of message output as in
previous releases of the product. The following LOGGING statement parameters are designed to
give a level of event recording reasonably close to what was provided by previous releases of Cisco
IOS for S/390:
LOGGING PRINT(ALL,(DN,RFEW),(IF,RFEWIS))
WTO((LL,RFEWIS),(CF,RFEWI))
You may find that there are other defaults you will wish to change. The LOGGING parameters can
be changed dynamically by means of the new LOGGING command, making it easy to experiment
with different configurations.
For complete information on the LOGGING statement, and the LOGGING operator command, refer
to the Cisco IOS for S/390 documentation.
IJTCFG00 (4.1)
IJTCFG00 (5.2)
PROMPT|NOPROMPT
IFSPARM
ROUTECDE(list)
VMCFNAME(name)
GTFID(value)
MAXSTGPCT(below, above)
IFSPARM
PROMPT|NOPROMPT
DATASPACESIZE
VMCFNAME(name)
GTFID(value)
MAXSTGPCT(below, above)
TIMER(ticks)
TIMEZONE(ATLANTIC|
EASTERN|CENTRAL|
MOUNTAIN|PACIFIC|
char hours)
TRACENAME(name)
VSREPORT(interval) |
NOVSREPORT
LOGGING
CUSTNUM(cust_num)
KEY(auth_key)
AUTH
CUSTNUM(cust_num)
KEY(auth_key)
AUTH
ROUTECDE(list)