Filter
Top Products
Cisco IOS for S/390 Release 2.0 Release Notes 23
Installing Cisco IOS for S/390 Release 2.0
Table 10 X'C262'Instance Codes
C909xxx T01SISND
The following 4-byte code has been added to Table 116, “X’C909’ Instance Codes,” in the “API
Diagnostic Codes” chapter:
Table 11 X’C909’ Instance Codes
Installing Cisco IOS for S/390 Release 2.0
This section contains information about installing Cisco IOS for S/390 release 2.0.
Installation Requirements
Cisco IOS for S/390 Version release 2.0 is composed of the base Cisco IOS for S/390 release 2.0
distribution tape and a tape containing additional PTFs. You must install both tapes.
MVS Releases
Cisco IOS for S/390 release 2.0 requires MVS/ESA Release 5.1 or higher. MVS/SP releases are not
supported. OpenEdition support is available only at MVS/ESA Releases 5.x and above.
The MVS PTF associated with APAR OW30322 must be applied prior to starting Cisco IOS for
S/390 release release 2.0.
APF Authorizations
The PFSLOAD library is used with OpenEdition and contains Physical File System (PFS) modules.
It must be APF-authorized to work correctly.
If you use the SASLINK data set as described in the ALLOCT00 section of these instructions you
must also APF-authorize that library.
Link List Data Sets
TCPLOAD must never be in the link list. If SASLINK is used, you must place it after the LINK
library in any concatenation to ensure that the Cisco IOS for S/390 version of LSCNCOM is used.
Automated Operations Impact
The message
ACC210I Internet Protocol Task Started no longer displays to indicate that startup
has completed. A message will display indicating startup completion in Cisco IOS for S/390
release 2.0. The message number will vary, depending on the device you are using. The message text
will be
4-byte Code 2-byte Code Description
C262000B 6F0B SEPM storage verification failed
C909000C Unable to find a route because SO_DONTROUTE was set.