Filter
Top Products
Cisco IOS for S/390 Release 2.0 Release Notes 25
Installation Requirements
• DB2/CONNECT V5 requires Fix Pack WR09014. Do not apply Fix Pack WR09024.
Common Inet Sockets in OpenEdition
You must install the APAR OW20620 in order to use Common Inet sockets in OpenEdition.
RS6000
You must install the RS/6000 patch U432867 to use the CLAW driver. With earlier RS/6000
maintenance, MVS error recovery problems can occur.
VTAM Release 3.3
VTAM Release 3.3 users must apply PTF UY67100 or UY69746, or their equivalent. If this is not
possible, contact Cisco TAC and request APAR MB18602. If the PTFs or APAR are not applied,
problems can occur handling control vector X’5F’ and cause connection errors.
MVS/ESA Release 5.1 Considerations
Interlink 3722 users must install the latest release of the CETI microcode. Interlink 3762 users must
install the latest release of the ECA CETI microcode. The CETI driver may terminate at startup if
you are using earlier releases.
Novell LAN Workplace
We recommend that you apply Novell fixes LWP41N and LWP168 (to correct an FTP hang
condition). These fixes are available on NetWire.
Walker, Richer, & Quinn Software
If you are using software from Walker, Richer, & Quinn, we recommend that you install version
2.1.2 or above of Reflection 8+ (for DOS using IBM 3270) and Version 2.2 of WRQNET TCP/IP.
Users of earlier releases can experience a tn3270 hang condition.
Hardware Requirements
These minimum hardware levels are required for Cisco IOS for S/390 release 2.0, including Cisco
IOS for S/390 Fault Tolerant:
Interlink 3762 ECA CETI 3.0 Checksum B030
Interlink 3762 TCA 4.0 Checksum 5841
Interlink 3762 FCA 2.5 Checksum 6273
Interlink 3722 ELC2 CETI 2.2 Checksum 67FE
Interlink 3722 ELC2 8232 3.1 Checksum 4132
IBM 2216 MAS V1 R1.1
IBM 3172 Model 3 ICP 3.3
IBM 3172 Model 1 ICP 1.1 and higher (ICP 1.1 with patch PLXXX48)
NSC HYPERchannel DX CDA 7.2