Filter
Top Products
Chapter 1 Product Overview
Front-Panel LEDs
1-6
Cisco SN 5428-2 Storage Router Hardware Installation Guide
OL-4797-01
The 10/100 Ethernet management port, MGMT 10/100, has two LEDs, labeled
ACT and SPEED. The ACT LED is located at the left-bottom corner of the port;
the SPEED LED is located at the right-bottom corner of the port.
The 10/100 Ethernet HA port, HA 10/100, has two LEDs, labeled ACT and
SPEED. The ACT LED is located at the left-bottom corner of the port; the SPEED
LED is located at the right-bottom corner of the port.
Each Fibre Channel port, FC 1 through FC 8, has two LEDs, labeled ACT and
LOG. The LEDs are located to the left of each Fibre Channel port.
Table 1-1 describes the LED indications.
Figure 1-3 SN 5428-2 Front-Panel LEDs
1 Gigabit Ethernet port, GE 1 4 10/100 Ethernet management port,
MGMT 10/100
2 Gigabit Ethernet port, GE 2 5 10/100 Ethernet HA port,
HA 10/100
3 FAULT, STATUS, and POWER 6 Fibre Channel ports, FC 1 through
FC 8
Table 1-1 LED Indication Descriptions
LED Color Description (when LED is on)
GE 1 and
GE 2 LEDs
LINK Green Port is operational.
TX Green Packets are being transmitted.
RX Green Packets are being received.
FAULT Red On if error condition in entire storage router.
Flashing if error condition in a storage router
component.
1 2 3 4 5 6