Filter
Top Products
Debug Commands
46
Release 11.3(4)NA
debug cable-modem error
Use the the debug cable-modem error Privileged EXEC command to enable debugging messages
for the cable interface driver. The no form of this command turns debugging messages off.
[no] debug cable-modem error
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3 NA.
This command displays detailed output about the sanity checking of received frame formats, the
acquisition of downstream QAM/FEC lock, the receipt or non receipt of SYNC messages from the
CMTS, reception errors, and bandwidth request failures.
Sample Display
Figure 6 shows sample display output for the debug cable-modem error command.
Figure 6 Sample Debug Cable-Modem Error Output
uBR904# debug cable-modem error
*Mar 7 20:16:29: AcquireSync(): Update rate is 100 Hz
*Mar 7 20:16:30: 1st Sync acquired after 1100 ms.
*Mar 7 20:16:30: Recovery loop is locked (7/9)
*Mar 7 20:16:30: 2nd Sync acquired after 100 ms.
*Mar 7 20:16:30: Recovery loop is locked (10/15)
Related Commands
debug cable-modem bpkm
debug cable-modem bridge
debug cable-modem interrupts
debug cable-modem mac
debug cable-modem map