Filter
Top Products
— 37 —
4.14 Paper Retraction
1. This printer has a function of automatically collecting the ejected paper. This
function is enabled or disabled by the memory switch. For memory switch
setting, refer to “7.2 Memory Switch Functions”.
2. After print paper is cut, paper is collected after a certain period of time has
passed with the presenter loaded with paper.
3. The time can be adjusted by a command.
4. Before collecting the ejected paper, allow a space for paper path at the
mounting area and at the bottom of the printer and prepare a collection box.
For details, refer to “5.2 Notes on Paper Collection Hole and Collection Path”.
4.15 Self-printing
1. This printer has a function of printing a set of predetermined characters.
Turn on the printer while pressing the FEED switch. Hold the FEED switch
pressed for about 1 second and then release the FEED switch. Then the
printer starts self-printing. Model name, ROM version, DIP switch status,
memory switch status, and built-in characters are printed.
2. After self-printing is completed, the printer performs initialize operation and
is ready for printing.
CAUTION!
Do not print with low paper supply.
4.16 Hexadecimal Dump Feature
1. This printer has the function to print data sent from the host in hexadecimal
numbers and the corresponding characters. With the printer cover open
and pressing and holding the FEED switch, turn the printer power on and
then close the cover. The printer starts initialization and prints “HEX DUMP
PRINT MODE” followed by printing of data received thereafter in hexadecimal
numbers and characters.
2. After the printer stops printing, turn the printer power off or press the FEED
switch three times or apply a reset signal from the interface, then the printer
executes initialization and enters the standby state.
CAUTION!
● Do not print in paper low condition.
● If there is no character corresponding to data, the printer prints “.”.
● During hexadecimal dump printing, commands other than DLE EOT, DLE ENQ, and
DLE DC4 provide no function.
● If the print data is less than a line, printing is caused by the occurrence of a certain
offline factor (pressing the FEED switch or the like).