Filter
Top Products
How to Use the Board
COM-2(PC)F 15
Compatible Mode Installation Procedure 1
It can’t be used with Compatible Mode when API-SIO(98/PC)NT
of packing together is used for API-PAC(W32).
1. Set the operation mode (I/O address) and interrupt level for the
COM-2(PC)F. Set the COM-2(PC)F switch and jumpers as
described in Hardware Setup. Set an interrupt level that is not
currently used by the computer.
2. Insert the COM-2(PC)F in an expansion slot and turn on the
power to the PC.
3. After Windows 2000 starts, select [Control Panel] from
[My Computer] and start the [Add/Remove Hardware].
4. Click [Next >] in response to [Welcome to the Add/Remove
Hardware Wizard] in the Add/Remove Hardware Wizard.
5. Select [Add/Troubleshoot a device] in response to [Choose a
Hardware Task].
6. The next, select [Add a New Device] and click [Next].
7. Select [Yes] in response to [Do you want Windows to search for
your new hardware ?], and click [Next].
8. It confirms that two [Install Communications Port] sentences are
indicated on the [Detected Hardware], and click [Next].
9. After rebooting, use the procedure described in the "Check
Resources" section below to check the interrupt level assigned
to the COM-2(PC)F. If the value is different to the level set on
the jumper, correct the setting in the OS.
10.When installing by this method, the COM-2(PC)F channels are
installed as standard serial ports (COM*).