Filter
Top Products
Installation (Windows NT)
PowerStorm 300 AGP and 300/350 PCI Graphics Controllers 4–3
1.
Put on an anti-static wriststrap.
2.
Use a 3/16-inch nut driver to remove the two nuts, located on either side of the VGA
connector, that secure the ATX bulkhead bracket to the PowerStorm 300 AGP
graphics controller.
3.
Remove the ATX bulkhead bracket.
4.
Install the NLX bulkhead bracket onto the graphics controller.
5.
Secure the NLX bulkhead bracket to the PowerStorm 300 AGP graphics controller
with the two nuts that were removed in step 2.
4.2.2 Installation of the Graphics Controller
The following section describes the installation procedure for the PowerStorm 300 AGP or
300/350 PCI graphics controller. To install the graphics controller, follow these steps:
__________________________ Note _____________________________
Before installing the graphics controller, check your monitor specification for
signal compatibility and supported features offered by the graphics controller.
____________________________________________________________
_________________________Caution ___________________________
Static electricity can damage sensitive electronic components. When handling
your graphics controller, use an anti-static wriststrap that is connected to a
grounded surface on your workstation. The wriststrap must be worn when
handling any graphics controller to prevent damage.
____________________________________________________________
1.
Shut down your workstation and disconnect the monitor cable.
2.
Disconnect the power cord from your workstation.
3.
Remove the cover from your workstation (refer to your workstation documentation).
4.
Put on an anti-static wriststrap.
5.
If your workstation has an existing graphics controller, remove the screw that secures
it and then remove the controller.
6. Choose a slot on the Primary PCI bus (in the Compaq Professional Workstation
XP1000, the top 3 slots); remove the slot cover if you are using a new slot.