Filter
Top Products
Installation (Windows NT)
4–8 PowerStorm 300 AGP and 300/350 PCI Graphics Controllers
4.3.7 Stereo Capability (PowerStorm 350 PCI Only)
__________________________ Note ____________________________
Only the PowerStorm 350 PCI graphics controller supports stereo capability.
___________________________________________________________
In order to activate the stereo feature of the PowerStorm 350 PCI graphics controller, the
following steps must be taken prior to running a stereo application:
1.
From My Computer, choose Control Panel.
2.
Choose Display.
3.
Choose the REALimage (tm) Settings tab.
4.
Check the Stereo box.
5.
Choose OK or Apply.
6.
When a message displays stating that you must reboot your workstation to use the new
settings, choose Yes. (The new settings will not be applied unless you reboot your
workstation.)
Once your workstation is rebooted with the stereo feature turned on, you can run stereo
applications. When a stereo application becomes active, all 2D and 3D applications will
run in stereo mode. This will affect performance of 2D and non-stereo 3D applications.
Stereo mode is turned off once the last 3D stereo application exits.
Please note that the stereo feature is disabled if you are running dual PowerStorm 350 PCI
graphics controllers.