Compaq 300 Network Card User Manual


 
Installation (Compaq Tru64 UNIX)
PowerStorm 300 AGP and 300/350 PCI Graphics Controllers 6–5
If this is not the path to the kit on your CD-ROM, you may need to search for the
appropriate file on the CD-ROM by looking for the
tar
extension.
6.3.2.2 Unpacking the Kit
This section describes the procedure for unpacking the compressed kit into a directory
structure on your local filesystem. It is assumed that the compressed kit distribution file
exists as
/var/tmp/PS3x0UNIX.tar
.
1.
Change to the directory where you copied the kit distribution file:
# cd /var/tmp
2.
Use
tar
to unpack the tar file into a directory structure:
# tar xvf PS3x0UNIX.tar
This will create the
PS3x0UNIX
directory and populate it with the kit files.
6.3.2.3 Installing the Kit
This section describes the procedure for installing PowerStorm 300/350 UNIX Graphics
Support. It is assumed that the kit has been obtained and unpacked into the
/var/tmp/PS3x0UNIX/
directory.
1.
Ensure that the system in which you wish to install PowerStorm 300/350 UNIX
Graphics Support does not already contain a DIGITAL Open3D kit.
To determine if DIGITAL Open3D subsets are installed on the system, enter the
command:
# setld -i | grep O3D | grep installed
If any of these subsets are installed, you must de-install them using the setld -d
command. For example, to remove the OpenGL support files, you would enter:
# setld -d O3DDWSGLBASE491
2.
Make sure that you are in the directory where you unpacked the kit:
# cd /var/tmp/PS3x0UNIX/
3.
Start the installation.
Start the installation by entering the setld command with the -l (load) function,
specifying the current directory as the location of the kit:
# setld -l .
4. Specify the subsets you wish to install.
The installation procedure displays the list of subsets available for installation and
prompts you to choose the desired subsets.
*** Enter subset selections ***