Filter
Top Products
Installation (Windows NT)
4–6 PowerStorm 300 AGP and 300/350 PCI Graphics Controllers
Keyboard: XT, AT, or Enhanced Keyboard (83-104 keys)
Keyboard Layout: US
Pointing Device: Mouse Port Mouse
No Changes: The above list matches my computer
When you have completed the Windows NT installation, go to Section 4.3.5.
__________________________ Note ____________________________
On the Intel platform, some monitors are unable to display the refresh rate used
during a short period of the initial installation of Windows NT 4.0 when using
the PowerStorm 300. This occurs after the first part of a fresh installation of
Windows NT following the period when the files are copied to the hard drive,
but before Windows NT displays the first full color display screen. If you have
chosen to use NTFS as your file system you may need to press the Enter key
during the period while the screen is black to begin the process of converting the
file system from FAT to NTFS.
___________________________________________________________
4.3.5 Installing/Upgrading PowerStorm Software Display Drivers
If you have purchased the PowerStorm 300 AGP or 300/350 PCI graphics controller as an
option, you must install the Compaq PowerStorm 300/350 display drivers. To install the
2D and 3D drivers (the Compaq optimized OpenGL support) from the Compaq
PowerStorm software CD, follow these steps:
1.
Boot your workstation and log into Windows NT if you have not already done so.
2.
From the desktop, choose My Computer.
3.
Choose Control Panel.
4.
Choose Display.
5.
Choose the Settings tab.
6.
Choose the Display Type button to see the driver and adapter (board) information.
7.
Choose Change.
8.
Choose Have Disk.
9. In the Install from Disk dialog box, you are prompted to insert the manufacturer’s
installation disk into the selected drive. Insert the Compaq PowerStorm Software CD
into the CD-ROM drive.