Filter
Top Products
Installation (Compaq Tru64 UNIX)
6–2 PowerStorm 300 AGP and 300/350 PCI Graphics Controllers
PowerStorm 300/350 UNIX Graphics Support is a supplemental kit that only supports the
PowerStorm 300 and PowerStorm 350 graphics controllers. This kit requires Tru64 UNIX
Version 4.0E or 4.0F, and is only supported on the Compaq Professional Workstation
XP1000.
This release contains optional support for the OpenGL graphics libraries and API support.
6.2 Hardware Installation
The following section describes the installation procedure for the PowerStorm 300/350
PCI graphics controller.
6.2.1 Installation of the Graphics Controller
__________________________ Note ____________________________
Before installing the graphics controller, check your monitor specification for
signal compatibility and supported features offered by the graphics controller.
___________________________________________________________
________________________ Caution___________________________
Static electricity can damage sensitive electronic components. When handling
your graphics controller, use an anti-static wriststrap that is connected to a
grounded surface on your workstation. The wriststrap must be worn when
handling any graphics controller to prevent damage.
___________________________________________________________
To install the graphics controller, follow these steps:
1.
Shut down your workstation and disconnect the monitor cable.
2.
Disconnect the power cord from your workstation.
3.
Remove the cover from your workstation (refer to your workstation documentation).
4.
Put on an anti-static wriststrap.
5.
If your workstation has an existing graphics controller, remove the screw that secures
it and then remove the controller.
6.
Choose a slot on the primary PCI bus (in the Compaq Professional Workstation
XP1000, the top 3 slots); remove the slot cover if you are using a new slot.
7. Grasp the top edge of the graphics controller and carefully insert it into the slot, then
firmly seat it.
8. Secure the retaining bracket.