Filter
Top Products
Installation (Compaq Tru64 UNIX)
PowerStorm 300 AGP and 300/350 PCI Graphics Controllers 6–7
The installation procedure generates messages as it checks that your system has
enough space to install the requested subsets, copies these subsets, and then verifies
that they were copied correctly.
Checking file system space required to install selected subsets:
File system space checked OK.
6 subset(s) will be installed.
Loading 1 of 6 subset(s)....
PowerStorm 300/350 Support V1.2 Base
Copying from . (disk)
Verifying
Loading 2 of 6 subset(s)....
PowerStorm 300/350 Support V1.2 OpenGL Base
Copying from . (disk)
Verifying
.
.
.
6 of 6 subset(s) installed successfully.
Configuring "PowerStorm 300/350 Support V1.2 Base" (O3DDWSBASE495)
.
.
.
Configuring "PowerStorm 300/350 Support V1.2 Config" (O3DDWSCONFIG495)
**** Auto Kernel Configuration ****
*** KERNEL CONFIGURATION AND BUILD PROCEDURE ***
Saving /sys/conf/[NODENAME] as /sys/conf/[NODENAME].bck
7.
Indicate whether you wish to modify the configuration file.
Do you want to edit the configuration file? (y/n) [n]:
The configuration file contains a variety of parameters that enable you to define
information used by the system at startup.
Enter ‘y’ if you wish to edit the configuration file. Press Return if you do not wish
to edit the configuration file.
8.
Dismount the CD-ROM drive from the mount point.
For example, to dismount mount point /mnt, enter the command:
# umount /mnt
9. Remove the CD from the CD-ROM drive.