Filter
Top Products
Installation (Compaq Tru64 UNIX)
PowerStorm 300 AGP and 300/350 PCI Graphics Controllers 6–3
9.
Replace the workstation cover.
10.
Ensure that the monitor cable is connected to the video output connector located on
the back of the graphics controller.
11.
Reconnect the power cord, and restart your workstation.
6.3 Software Installation
This section describes the installation of PowerStorm 300/350 software for the Tru64
UNIX operating system.
6.3.1 Installation Preparation and Information
6.3.1.1 Required License
PowerStorm 300/350 UNIX Graphics Support software requires an Open3D Product
Authorization Key (PAK) for OpenGL server operation. A hardcopy of this PAK is
provided with your hardware and should be registered using the License Management
Facility (LMF) before you install PowerStorm 300/350 UNIX Graphics Support. If you do
not register the PAK before starting the software, the server will run in 2D mode only
(without OpenGL server support).
If your PowerStorm 300/350 graphics controller hardware and software came pre-installed,
the PAK will already be registered.
For complete information on using the Tru64 UNIX License Management Facility, see the
Software License Management guide or the
lmf(8)reference page.
6.3.1.2 Prerequisite Software
You can install PowerStorm 300/350 UNIX Graphics Support only on systems that are
running Tru64 UNIX Version 4.0E or 4.0F.
__________________________ Note _____________________________
Before installing PowerStorm 300/350 UNIX Graphics Support, you must
remove all versions of DIGITAL Open3D from the system. After you have
installed PowerStorm 300/350 UNIX Graphics Support, if you upgrade or
reinstall the operating system, you must first de-install PowerStorm 300/350
UNIX Graphics Support. Once the operating system update has completed, you
may reinstall PowerStorm 300/350 UNIX Graphics Support.
____________________________________________________________