Filter
Top Products
MP1400 Microportable Projector 2-7
Part Number: part number 177284-001 - Writer: Marianne Silvetti - Saved by: Marianne Silvetti
Pages: 8 Words: 1421 Saved date: 05/12/004:32 PM File Name: Chap2.doc
■
Management—Allows the user to control power saver
characteristics of the display, or to view the cumulative lamp
hours, reset the lamp hour timer, view the unit’s serial number,
or perform a Master Reset.
■
Factory Reset—Resets the current operating option to its
original factory setting.
Special On-Screen Messages
The following on-screen messages will appear on the projection
display to identify the following conditions:
■
Check Video Cable—
Indicates the video cable may not be
plugged into the projector or the selected video input is not
accurate.
■
Input Signal Out of Range—
Indicates the projector is unable
to access the appropriate input signal.
■
2 Inputs Active - Remove One—
The projector has two data
inputs: one is an analog D-Sub input, and the other is a digital
DFP input. This message indicates that both inputs are active
simultaneously and the user should detach one of them.
■
Going to Standby—
Indicates the projector is entering a sleep
mode or is powering off the lamp.
■
Lamp May Fail Soon, Replacement Suggested—
Indicates
the lamp is approaching failure. The message will remain on
the screen for five seconds or until the on-screen menu
Select
button is pressed.