Filter
Top Products
Troubleshooting A-5
Writer:M. Silvetti Saved by: Marianne Silvetti Saved date: 05/12/00 4:29 PM
Part Number:177284-001 File name: DAppA.doc
Solving Lamp Problems
Lamp shuts off
1. If all five projector panel buttons
flash amber, the projector has
overheated and will automatically
shut down. Wait 5-10 minutes
until the buttons stop flashing
and the
Standby
button turns
amber before restarting the
projector again.
2. A minor power surge may cause
the lamp to shut off. Turn the
projector off. Wait a few minutes,
then turn it back on.
Lamp burns out or makes a
popping sound
When the lamp reaches its end of life,
it will burn out and may make a loud
popping sound. If this happens, the
projector will not turn back on until
the lamp module has been replaced.
For information on purchasing a
replacement lamp module, call your
Compaq authorized dealer, seller, or
reseller. To locate a reseller near you,
call 1-800-AT-COMPAQ. To purchase
directly from Compaq, visit the
Compaq web site at
http://www.compaq.com/products/
projectors.
To replace the lamp, follow the
procedures in the
“
Replacing the
Projector Lamp Module
”
section in
Chapter 5,
“
Care and Maintenance
.”