Filter
Top Products
60
www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-245U-E Wireless Ethernet & Device Server User Manual
Connect to the web page of the module that will be performing the Iperf test, select “System Tools” link on the right hand side of the webpage and
then select “TCP Throughput Test” and you will see the Screen as shown below.
Note: TCP Throughput test must be run using Microsoft Internet Explorer 8 or later.
Enter the IP address of the remote device that you wish to test and press the “Measure Throughput” button.
The specified IP address must be running Iperf in Server mode (if the remote modem does not have the Iperf server running then you will get the
following Error message on the web page, “Iperf error, check connectivity to server.” Ensure that it has been enabled and the module has been
reset. Each press of the “Measure Throughput” button will perform a TCP throughput test of 10 second duration.
You will see the message “Performing Iperf Test” text and and if you look at the modules you will see the TX/Link & RX Led’s flashing very fast as
it performs the test. Approximately 10 seconds later a graph showing the actual throughput over the 10 second period and a calculated average
will be displayed.
The graph below shows the data throughput range between 8 and 14.5Mbits per second with an overall average of 10.9Mbits per second.
It is recommended to perform this throughput test a number of times to get better sample of the overall throughput.
3A1576Rev1.6