CyberResearch CPEN GX-333-X Personal Computer User Manual


 
CyberResearch
®
CPU Cards CPEx GX-333-X
CyberResearch, Inc. 57
25 Business Park Drive P: (203) 483-8815; F: (203) 483-9024
Branford, CT USA www.cyberresearch.com
Î Base Memory:
The Base Memory is NOT user configurable. The POST will determine the amount of base (or
conventional) memory is installed in the system. The value of the base memory is typically 512K
for systems with 512K memory installed on the CPU card or 640K for systems with 640K or more
memory installed on the motherboard.
Î Extended Memory
The Extended Memory is NOT user configurable. The BIOS determines how much extended
memory is present during the POST. This is the amount of memory above 1MB located in the
memory address map of the CPU.
Î Total Memory
The Total Memory is NOT user configurable.
IDE Channel Master
The IDE Channel Master menu allows you to set or change the configurations for the master and
slave IDE devices for both channel 0 and channel 1.
Î IDE HDD Auto-Detection [Press Enter]
Selecting IDE HDD Auto-Detection option and pressing the “E
NTER” key will enable the BIOS to
automatically detect the HDD type. Do not set this option manually.
Î IDE Channel 0/1 Master/Slave [Auto]
The IDE Channel option allows you to activate or deactivate the following drive channels:
1. Channel 0 Master
2. Channel 0 Slave
Î
None
If you have no drives connected to the IDE channel
select this option. Once set, this IDE channel will
become inaccessible and any drives attached to it
undetected.
Î
Auto
(D
EFAULT) Setting this option allows the device to be automatically
detected by the BIOS
Î
Manual
Selecting this option allows you to manually configure
the device on the IDE channel in BIOS.
Î Access Mode [Auto]
The Access Mode option allows you to determine the hard disk BIOS translation modes. Most
systems now use hard drives with large capacities and therefore either the LBA translation mode
or auto should be selected.
Î
CHS
Select this mode if the HDD capacity is less than
504MB.
Î
LBA
Select this mode if the HDD capacity is more than
8.4GB.
Î
Large
This mode is an extended ECHS mode and while it
supports HDDs larger than 504MB, it is not
recommended.
Î
Auto
(D
EFAULT) If you are unsure of what access mode to set, select
this option